When using the Link MC/5 terminal for operation with either CCI Concurrent DOS or Multiuser DOS, the settings below are recommended. To enter the SETUP mode on a Link MC/5 terminal, press SHIFT-SELECT. Options which differ from the factory settings are marked with an asterisk (*). Notes: 1. A "?" as a field value means no preference. 2. The Host MUST be on the MAIN port. Hit the "P" key if it displays AUX port. 3. Run the TERMSET command with the syntax "TERMSET ST n MC5" (where n = stattion number) to define this port properly. 4. The settings detailed here are with firmware Version 3.02. The differences between this document and earlier versions should not affect the ability of the terminal to run in a multiuser environment.
	F1 General Emulation = PCTERM               Autopage = OFF Enhancements = OFF               Warning Bell = ? Virtual Terminal = OFF              Margin Bell = OFF Scroll Style = Jump                   Bell Sound = ? Autoscroll = ON                        Block Terminator =US/CR Autowrap = OFF                       Send ACK = Off Received CR = CR                    Monitor mode = OFF		F4 Keyboard Keyclick = ?                         Break = 250ms Key repeat = ON                   XMT Limit = 60cps Key lock = CAPS FKEY        XMT Linit = 60cps Return Key = CR                   Key Code = Scan Enter key = CR WP               Kbd Mode = Off Backspace key = DEL/BS      Lock Kbd = Disable Left Alt key = Funct                Language = US Delete Key = Normal
	F2 Communication Main Rcv Baud = 38400      Aux Baud = 9600 Main Data/Parity = 8/None          Aux Data/Parity = 8/None Main Stop Bits = 1             Aux Stop Bits = 1 Main Rcv Hndsk = DTR/XPC       Aux Rcv Hndsk = XON/XOFF Main XMT Hndsk = None    Aux XMT Hndsk = XON/XOFF Main Rcv Level = ?             Aux Rcv Level = 50% Ignore 8th Bit = Off             Aux Port = RS232 Comm Mode=Full Duplex   Aux Interface = RS232 Disconnect = 2 sec            Printer = ?
			F5 ANSI Fkey Lock = OFF            Print = National Feature Lock = OFF                    Port = EIA DATA Keypad = Application       Send Area = Screen XferTerm = EOS               Print area = Screen Cursor keys=Application   Send Term = FF Margin Ctrl = 0                  Print term = FF Char Mode = National        Print Mode = Normal Keys = Typewriter             VT100 ID = VT100 Send = All                       Auto Answerback = OFF
	F3 Display Columns = 80                          Background = Dark 80/132 Clear = OFF *               Attributes = Char Lines = 25                               WPRT Intensity = DIM Pages= 1 x lines                      WPRT Reverse = OFF Status line = ON *                    WPRT Underline = OFF Cursor style = ?                       Line Refresh rate = 60HZ Cursor = ON                            Pound Char = US Screen Saver = ?                     Autofont load = OFF